EX9000/EX9000-Modbus Series
     
   
 
 
EX9254-MTCP        5 differential DI & 8 open drain DO with ModbusTCP daisy chain module
 

Special Features:

 

■ 2-ports(RJ-45) Ethernet 10/100 Based-T Comm.
■ Daisy chain connection with auto-bypass protection
■ Support Modbus/TCP,TCP/IP,UDP,ICMP,ARP
■ Support Automatic DIO Sync.(peer-to-peer).
■ DO Auto-Off Time Mode.
■ Support 8 Isolated with open drain (P-MOSFET), 750mA/channel.
■ Support 5 Isolated differential digital input
■ Fully Photo-Isolation 3750Vrms
■ Protocol: ASCII Format & Modbus TCP

  

Specifications/ 
   
Interface:
Communication 2-port(RJ45) Ethernet 10/100 Based-T comm, Daisy chain connection with auto-bypass protection.
Protocol Modbus/TCP, TCP/IP, UDP, ICMP and ARP
Led indication Led for power and Ethernet link status
Isolation Digital Input:
Input channels 5 (DI0~4)
Input type: differential
     ● logic level 0 (active) : +5V to +30VDC max
     ● logic level 1 (inactive): +0V to +1VDC max
Logic level status can be inversed via ASCII/Modbus command
Input Impedance 2K ohm
Counter Input 300Hz counter input (32-bit+1-bit overflow)
Optical Isolation Voltage 3750Vrms
Isolation Digital Output:
Output channels 8 (DO0~7)
Output type: Isolated open drain (P-MOSFET)
Load voltage: +10V to +30VDC
Load current: 750mA/ channel Max. (With short-circuit protection)
Logic level status can be inversed via ASCII/Modbus command
Pulse output Each channel supports 300Hz pulse output
Optical Isolation Voltage 3750Vrms
Power requirement:
Consumption 3.6W (Typical)
Power input 10~30VDC
Operating temperature: -10 ~ 70° C (14 ~ 158° F)
Operating temperature: -25 ~ 85 °C (13 ~ 185 °F)
Humidity 5~95% RH, non-condensing


 

Features:

 

 

 

Automatic DIO Synchronization (peer-to peer)
EX9200-MTCP series module also provide a Automatic DIO Synchronization function. With peer-to-peer networking, users can define the mapping between a Pair of EX9200-MTCP series modules so that input values will be directly transferred to output channels. A single digital output channel(Local/ Remote device) is activated(1/0 or toggle)dependent on the digital input channels state data pattern. When the specified DI channels state data pattern changed from “Match” to “Not match” the corresponding DO well be set to active(1 or 0).

 

 

  larger photo
     larger photo
   
   User Manual
 

Driver

       9000-MTCP Utility

       Demo
     Pin Assignment
Block Diagram
  Wire-connection